Swanstone KSTB-4422 - Installation - Manual (Page 7)

10. Connect the drain trap fittings per the manufacturer’s
instructions.
11. Connect the faucet per the manufacturer’s instructions.
12. Connect the drain lines and p-trap. Also connect the
disposal (if desired), per the manufacturer’s instructions.
13. Connect the faucet supply lines per the manufacturer’s
instructions.
14. Check for leaks.
a. Check water supply lines to faucet.
b. Fill sink with water and check for leaks around drain.
c. Release water from the sink and check for leaks in
the plumbing.
d. Tighten any component that is leaking and retest.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
Care and Cleaning
The Swanstone products are stain and abrasion resistant;
however, the finish requires reasonable care.
Because cleaning products change over time, always check the
manufacturer’s instructions to make sure it is compatible with
plastic. DO NOT use a cleaner if the label indicates it should
not be used on plastics. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to stop
the chemical cleaning reaction because damage will result and
void the warranty.
Day-To-Day Cleanup
Clean your Swanstone kitchen sink with powdered abrasive
cleaners. Use of a Scotch Brite pad is recommended to
remove stubborn stains. Occasional use of a mild bleach and
water solution ensures that the original luster is maintained.
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can be
cleaned with warm water, a soft cloth, and normal household
detergents or cleansers, such as Fantastic, Formula 409,
Clorox Clean-up, Handy Andy, Mr. Clean, or Lestoil. Always
rinse off cleaners within five minutes of application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Surface Repair
Light Scratches
Use 400 grit sandpaper to remove light scratches in the
surface.
Deep Scratches or Gouges
For deeper scratches or gouges, use 220 or 320 grit
sandpaper. A “Scotchbright pad” can be used to blend the
repair into the surrounding area.
IMPORTANT NOTICE
KS-012
KS-011
KS-010
KS-009
800-325-7008 7 The Swan Corporation – Swanstone
Installation Procedure Care and Cleaning