dbx DriveRack PA2 - Manual (Page 44)

40
®
LOW DELAY for the LOW outputs. If you’ve configured a 3-way system, you will see an additional MID DELAY for the MID
outputs. Turn and press the
DATA wheel to select the desired delay module. Turn the DATA wheel to scroll through the list
of parameters. Press the DATA wheel to edit a selection. When in a Delay menu, pressing and holding the DELAY button for
approximately 2 seconds will advance to the next delay module, wrapping around through the available modules.
• DELAY [ON, OFF]
Turns the selected delay module on and off.
• LENGTH (LOW, MID, and HIGH DELAYS) [0ms/0ft/0m - 10ms/11.27ft/3.43m]
Sets the delay time or length. Each pair of outputs has up to 10ms of delay time available for driver alignment delay. Delay
length will be displayed in all units at the same time (i.e., milliseconds, feet, and meters), making it easy to dial in the setting
for the units you prefer. Delay lengths can be adjusted by the following increments: ~.02 ms/~.02 ft/~.01 meter.
• LENGTH (INPUT DELAY) [0ms/0ft/0m - 100ms/112.7ft/34.3m]
Sets the delay time or length. The input delay has up to 100ms of delay time available for backline delay. Delay length will
be displayed in all units at the same time (i.e., milliseconds, feet, and meters), making it easy to dial in the setting for the
units you prefer. Delay lengths can be adjusted by the following increments: ~.02 ms/~.02 ft/~.01 meter.