3B Scientific Power Function Generator (115 V, 50__60 Hz) - Manual

3B SCIENTIFIC® PHYSICS
1
Function Generator FG100 (230 V, 50/60 Hz)
Function Generator FG100 (115 V, 50/60 Hz)
1009957 / U8533600-230
1009956 / U8533600-115
Instruction Sheet
11/12 SD/ALF
1 Display
2 Offset button and Start/Stop
button for sweep function
3 BNC socket, input/output for
trigger
4 Button for setting waveform
5 Input for control voltage/output
for ramp
6 Button for selecting sweep mode
7 Output
sockets
8 Amplitude knob
9 Power socket for plug-in power
supply
10 Frequency knob
1. Safety instructions
The function generator FG100 conforms to safety regula-
tions for electrical measuring, control and laboratory
equipment as specified in DIN EN 61010 Part 1. It is to
be operated in dry rooms as appropriate for the use of
electrical equipment.
Safe operation of this equipment is guaranteed as long as
it is used as stipulated. However, there is no guarantee of
safety if the equipment is used incorrectly or carelessly.
If there is any suspicion that the equipment can no
longer be operated without risk (e.g. if visible damage is
detected), the equipment must immediately be with-
drawn from use and secured in such a way as to prevent
its inadvertent operation.
• Only use the instrument in a dry environment.
• Do not attempt to operate the equipment except
with its own power supply.
• Do not apply any external voltage to the output terminals.
• Do not exceed the maximum input voltage of 5 V for
the control voltage and trigger.
Electromagnetic waves can be generated, in particular at
high frequencies or with waveforms featuring a large
amount of harmonics, which may cause interference to
other equipment in the area.
• Ensure that no other equipment is being interfered
with.
• If necessary, only operate the FG100 function gen-
erator for short periods.
• Do not use experiment leads longer than 5 m.