3B Scientific Equipment Kit “Hysteresis Curve” User Manual
Page 2
Elwe Didactic GmbH ▪ Steinfelsstr. 6 ▪ 08248 Klingenthal ▪ Germany ▪
www.elwedidactic.com
3B Scientific GmbH ▪ Rudorffweg 8 ▪ 21031 Hamburg ▪ Germany ▪
www.3bscientific.com
Subject to technical amendments
•
Connect the power supply, coil and ammeter
in series (see Fig. 1).
•
Place a core inside the coil.
•
Secure the field probe in its retainer so that the
tangential probe is against the coil core.
•
Turn on the power supply and increase the
current to the coil until the magnetic flux den-
sity B approaches saturation. Make sure the
current to the coil does not exceed its 3-amp
limit.
•
Determine the magnetic field strength H from
the current to the coil I, the number of turns n,
and the length of the coil s.
s
I
n
H
⋅
=
•
Read the magnetic flux density B from a
teslameter.
•
Set the current back to zero, reverse the polar-
ity to the coil and conduct measurements in
the negative current range.
•
Plot the magnetic flux density as a function of
the magnetic field strength.
•
Repeat the experiment with various iron sam-
ples.
A
max. 3 A
Fig.1 Obtaining a hysteresis curve
Fig. 2 Example of a hysteresis curve