Beko CHA 28021 - Manual (Page 11)

GB
Instruction for use
Defrosting
A) Fridge compartment
The fridge compartment defrosts
automatically. The defrost water runs to the
drain tube via a collection container at the
back of the appliance (Item 6).
During defrosting, water droplets may form at
the back of the fridge compartment where a
concealed evaporator is located. Some
droplets may remain on the liner and refreeze
when defrosting is completed. Do not use
pointed or sharp-edged objects such as
knives or forks to remove the droplets which
have refrozen.
If, at any time, the defrost water does not
drain from the collection channel, check that
no food particles have blocked the drain tube.
The drain tube can be cleared with a pipe-
cleaner or similar implement.
Check that the tube is permanently placed with
its end in the collecting tray on the compressor
to prevent the water spilling on the electric
installation or on the floor (Item 7).
B) Freezer compartment
The NO FROST type defrost is compleetly
automatic. No intervention from your side is
requiered. The water is colected on the
compressor tray. Due the heat of the
compressor the water is evaporated
Never use hairdryers, electrical heaters or
other such electrical appliances for defrosting.
Sponge out the defrost water collected in the
bottom of the freezer compartment. After
defrosting, dry the interior thoroughly (Item 8
& 9). Insert the plug into the wall socket and
switch on the electricity supply.
Warnings!
1
The fan inside the freezer compartment
circulates cold air. Never insert any object
through the guard. Do not allow children to
play with the freezer fan.
Never store products that contain inflammable
propellant gas (eg dispensers, spray cans
etc.) or explosive substances.
Don’t cover the shelves with any protective
materials, which may obstruct air circulation.
Do not allow children to play with the
appliance or tamper with the controls.
Do not obstruct the freezer fan guard to
ensure that you obtain the best possible
performance from your appliance.
(Item 10)
Warning!
Your appliance is fitted with a circulating fan
which is essential for the performance of the
freezer. Please ensure the fan is not blocked
(stopped) or impaired by food or packaging.
Blocking (stopping) or impairing the fan can
result in an increase of the internal freezer
temperature (Thawing).
Replacing the interior light bulb
(Item 11)
In case that the light bulb is out of function it is
easily to replace. First make sure that the
refrigerator / freezer is disconnected from the
power supply by removing the plug. Take a flat
screwdriver and keep it carefully without force
into the left gap between lamp cover and
internal cabinet. Then press the handle of the
screwdriver carefully to the left side until you
notice that the left pin of the cover is
disengaged . Repeat this procedure on the right
gap, however now press the handle of the
screwdriver carefully to the right side. If both
sides are loosened the cover can be removed
easily.
Ensure that bulb is screwed securely in the bulb
holder. Plug the appliance into the power
supply. If the light still fails, replace E14 screw-
cap type 15 Watt (Max) bulb from your local
electrical store and then fit it. Carefully dispose
of the burnt-out light bulb immediately.
If you have changed the light bulb please fix the
cover again in it’s former position. Take care
that the cover snaps-in correctly.
Cleaning and care
1. We recommend that you switch off the
appliance at the socket outlet and pull out the
mains plug before cleaning.
2. Never use any sharp instruments or
abrasive substances, soap, household
cleaner, detergent or wax polish for cleaning.
3. Use luke warm water to clean the cabinet
of the appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution
of one teaspoon of bicarbonate of soda to one
pint of water to clean the interior and wipe it
dry.
5. Make sure that no water enters the
5