StreetGlow LED Singles - Manual

l.e.d. singles
CONTENTS:
4 - L.E.D. Singles with mounting collar
All necessary mounting hardware
INSTRUCTIONS:
1) Select desired location for mounting L.E.D.
2) Drill 1/4” mounting hole for L.E.D. bezel.
3) Remove mounting color from back of L.E.D.
4) Insert L.E.D. with bezel into mounting hole.
5) Press mounting collar firmly onto the back of the
L.E.D. and lock into position.
6) Connect striped wire to positive (+) 12v.
Connect BLACK wire to negative (-) ground.
7) Enjoy!
The retailer shall not be held responsible for any damages that
occur as a result of defective products. StreetGlow products are
recommended for show and off-road use only. Laws concerning the
use of aftermarket lighting products may vary from state to state.
For more information, check with your local authority.
Mounting collar
Surface