Baldwin Reserve Round Knob - Privacy - Manual

If not already installed, insert
the half round spindle
into exterior chassis.
After the completion of Step 1, install the longer half round spindle
supplied in the kit. Install the privacy pin on privacy products only. Proceed
to Step 3 and install with longer screws. During Step 5, install strike
supplied in the kit.
Privacy/Passage Knob and Lever Installation Instructions
Fits 1-3/8" (40 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
Pin
Place knob or lever onto chassis and turn set screw clockwise to secure.
Repeat for knob or lever on the other side.
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
Adjust tang as needed.
THICK DOOR KIT INSTALLATION INSTRUCTIONS
(AvAILAbLe SePARATeLy)
Supports 2" (51 mm) up to 2-1/2" (64 mm) doors
TeMPLATe
1-3/8"
(35 mm)
1-3/4"
(44 mm)
2"
(51 mm)
2-1/4"
(57 mm)
2-1/2"
(64 mm)
Centerline
Ligne médiane
Linea central
Fold
Doble
Plier
2-3/8" 60mm
2-3/4" 70mm 47038 / 01
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
Copyright © 2011 Baldwin Hardware Corporation
Note: For privacy knob or lever, make
sure the toggle is in the unlocked
position closest to the latch.
www.baldwinhardware.com • Customer Service 1.800.437.7448
Please note: Product
illustrations may differ
from your product.
Installation is the same.
If backset of door measured
2-3/4" (70mm), adjust latch shown
by grasping the spring pin and
moving it to the 2-3/4" slot.
Save the bedroom/bathroom emergency unlock tool for future use.
For privacy function only.
1. Adjust and install latch 4. Install knob/lever
5. Install strike
Measure your door backset as shown.
OR
For Drive In Latch
LATCH ASSeMbLy AND INSTALLATION
Install with 1/2" screws.
Snap on collar.
Drive in with hammer.
For Square Corner and Round Corner
Snap together front and back plate.
Make sure the slant of latch bolt faces in the direction that the door closes.
2. Install spindle
Push and hold in latch bolt, align curve of half round spindle
with latch, and install exterior chassis.
3. Install chassis
exterior chassis
interior chassis
Align curve of half
round spindle with
interior chassis and
install with screws.
exterior chassis
privacy pin
(for privacy function only)
longer half
round spindle
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
1"
25mm
1"
25mm
1"
25mm
Measure
after printing.