Crown Audio IQ-PIP-USP2_CN - Manual (Page 40)

IQ-PIP-USP2/CN
Page 40 IQ-PIP-USP2/CN Reference Manual
10.2.2 Presets Control Tab
The Presets Control Tab allows you
to store and recall PIP settings as
Presets within the IQ-PIP-USP2/CN
and assign each Preset a name
(see Section 9.1 for information
about Presets).
Checking the “Prompt to recall or
store” checkbox causes a prompt
to be issued whenever a Preset
button is pressed. The prompt gives
you the choice of Recalling the Pre-
set, Storing the Preset or Cancel.
When the check box is “unchecked,”
no prompt will be given, and all
settings contained in the selected
preset will be recalled and the cur-
rent setup lost when a Preset button
is pressed.
Important: To store current settings
as a Preset, the store button must
Figure 10.3 Presets Control Tab
first be pressed, then the desired
Preset button.
Preset 10 provides an example of a
typical setup for a very simple
Cobranet Network. When Preset 10
is recalled, the PIP will receive
bundle #1 and route Channel one to
amplifier input Channel one, and
Channel two to amplifier input Chan-
nel two. Preset 10 is intended as a
tool to help you get started and to
help you observe how audio is routed
into the amplifier. When this example
preset is no longer needed, you can
save your own Preset settings in
Preset 10 and rename it; however, if
the PIP is returned to factory default
settings, the example Cobranet
setup will again be stored in Preset
10. Figure 10.3 shows the Presets
Control Tab.