Braun 350cc-4 Series 3 EU - Manual (Page 15)

15
B Keeping your shaver in top shape
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Renew, and certainly when
the yellow cleaning light (7) shines constantly after shaving. If this is not
done, the yellow light will go out after some time. The shaver’s electronics
will then assume it has been cleaned manually and a new calculation of the
time when the next cleaning is required will be started. During the cleaning
process in the Clean&Renew the yellow light will flash and will go off after
approx. 4 hours when cleaning is finished.
Automatic cleaning
Once the shaver is put into the Clean&Renew, it is cleaned automatically
(see «C Clean&Renew»).
Manual cleaning is recommended only when the Clean&Renew is not
available, e. g. when travelling.
Manual cleaning
The shaver head is suitable for cleaning under running tap water.
Warning: Detach the shaver from the power supply before cleaning
the shaver head in water.
Regular cleaning ensures better shaving performance. Rinsing the shaver
head under running water after each shave is an easy and fast way to keep
it clean:
• Switch the shaver on (cordless) and rinse the shaver head under hot
running water. You may use liquid soap without abrasive substances.
Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver Foil & Cutter cassette (1)
and let it dry.
• If you regularly clean the shaver under water, then once a week apply
a drop of light machine oil onto the long hair trimmer (2) and shaver
Foil & Cutter cassette (1).
Alternatively, you may clean the shaver using a brush:
• Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap
it out on a flat surface.
• Using a brush, clean the inner area of the shaver head. However, do not
clean the shaver Foil & Cutter cassette with a brush as this may damage
it.
92020132_390cc4_S6-100.indd 15 92020132_390cc4_S6-100.indd 15 31.08.11 14:28 31.08.11 14:28