Zanussi ZRT724X - Manual (Page 22)

1. Fit the spacers into
the holes. Make sure
that the arrow (A) is
positioned as shown
in the picture.
2. Turn counter-clock-
wise the spacers
through 45° until
they lock into place.
45˚
A
Levelling
When placing the appli-
ance ensure that it stands
level. This can be ach-
ieved by two adjustable
feet at the bottom in front.
Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the appli-
ance is positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally, howev-
er, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by one
or more adjustable feet at the base of the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall
and the cabinet must be at least 10 mm to allow the
door to open enough so that the shelves can be removed.
Warning!
It must be possible to dis-
connect the appliance from
the mains power supply;
the plug must therefore be
easily accessible after in-
stallation.
min.100 mm
15 mm 15 mm
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during
the operations.
To change the opening direction of the door, do these
steps:
22