Anchor Audio Beacon Line Array - Manual (Page 8)

MADE IN USA
SIX YEAR WARRANTY
Beacon® Sound System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
BEACON TECHNICAL SPECIFICATIONS
Rated Power Output 150 watts AC / 125 watts DC
Max SPL @ Rated Power 120 dB
Battery
Two 12V rechargeable, 9.0 AH
Full recharge: approx 7 hrs
Frequency Response 60 Hz – 15 kHz ± 3dB
Line Output (post fader) isolated, 600
W , 1/4” phone
AC Power Reqs. 100 – 240 VAC, 50/60 Hz, 300W
max
DC Out
12V 500mA
USB 5V 500mA
Dimensions (HWD) 26.25” x 11” x 18” (66.7 x 28 x
45.7cm)
Weight
51 lbs / 23 Kg
Mic Inputs: Lo-Z (1 K W), balanced, XLR
12 VDC condenser mic (phantom)
power
Hi-Z (10 K W), unbalanced, 1/4” phone
Hi-Z (10 K W), unbalanced, 1/8” stereo,
1/4” phone
Line In/Out unbalanced, stereo RCA
Sensitivity For Rated Output
Lo-Z Microphone -52 dBV (2.5 mVrms)
Hi-Z Microphone -43 dBV (7.5 mVrms)
Auxiliary (line)
-14 dBV (200 mVrms)
Phantom Power 36V
(Specifications Subject to Change Without Notice)
Anchor Audio customer service
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE SOLUTION
No Sound (power LED off) • turn POWER switch ON
• charge battery or plug in AC cord
• safety shut down if unit overheats, turn volume lower & turn
speaker ON
No Sound (power LED on) • check for output from source
• make sure all cables are completely plugged in
• turn up volume control of input used
• remove plug from speaker output if not using external
speaker output
Shortened Battery Life • charge battery fully; if battery life continues to deteriorate,
contact Anchor Audio customer service: 800.262.4671
Distorted Sound • lower system volume control
Excessive Hum or Noise • use shielded cables
• use balanced microphone
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (Wireless Models Only)
CONDITION POSSIBLE SOLUTION
No Sound (RX Indicator: ON) • set MUTE switch to on (handheld mic only)
• turn up WIRELESS volume control
• make sure mic is plugged into body pack transmitter
No Sound (RX Indicator: OFF) • push mic power button
• turn Beacon POWER switch on
• make sure transmitter power switch is on
• set receiver and transmitter to same channel
• replace battery in transmitter
NEED MORE HELP? Beacon Sound System Setup & Operation Videos!
Visit Our Website: www.anchoraudio.com
8