Anchor Audio Acclaim Lectern - Manual (Page 2)

MADE IN USA
SIX YEAR WARRANTY
Acclaim Portable Lectern Sound System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
2
TOP PANEL OF ACL-7500U2
BACK PANEL OF ACL-7500U2
BASIC SYSTEM OPERATION
NOTE: Fully Charge Batteries Before First Use!
IMPORTANT: Make all connections with shielded cables to avoid
hum, buzzing or interference.
1. Set all Input Level Controls to minimum & Tones Controls
to flat (the middle setting) before turning your system on
2. Plug lectern gooseneck microphone into the Lectern Mic
Jack located on the tabletop
3. Switch POWER to ON, the BATTERY LED will light
4. Slowly increase the Level Control for the input jacks used
to the desired volume
5. Adjust BASS & TREBLE controls to desired sound quality
AUXILIARY MICROPHONE
INPUT JACK – XLR
Balanced - low impedance microphones,
powers condenser mics
SPEAKER OUT
OUTPUT JACK – 1/4” PHONE
Balanced - drives an unpowered 2 ohm speaker
in addition to the built-in speakers
LINE IN
INPUT JACK – 1/4” PHONE
Jack may be combined with mic inputs
for a composite output
For playback of tape/CD player or
other audio source
LINE OUT
OUTPUT JACK – 1/4” PHONE
Balanced - provides combined
output of all active system inputs
Record presentation / connect to another
powered sound system
ACCLAIM LECTERN TABLETOP
All Models
LECTERN
MICROPHONE
JACK
FRONT/SPEAKER
LECTERN TOP
CHARGE INDICATOR LIGHT
UHF WIRELESS RECEIVER
Available on selected models only
LINE IN
LEVEL CONTROL
WIRED MIC LEVEL
CONTROL
LOW BATTERY
INDICATOR LIGHT
POWER SWITCH
LECTERN LEVEL
CONTROL
WIRELESS MICROPHONE 1
LEVEL CONTROL
WIRELESS MICROPHONE 2
LEVEL CONTROL