Anchor Audio AN-1000X+ Speaker Monitor - Manual (Page 6)

MADE IN USA
SIX YEAR WARRANTY
AN-1000X+ Speaker Monitor Owners Manual
AN-1000X+ TECHNICAL SPECIFICATIONS
(Specifications Subject to Change Without Notice)
Anchor Audio customer service
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
6
Rated Power Output 50 watts continuous @ 4 W
Max SPL @ Rated Power 107 dB @ 1 meter
Frequency Response
65 Hz – 20 kHz ± 3 dB
Speaker Type 4.5” woofer with shielded magnet,
10mm dome tweeter
AC Power Reqs. 110 – 125Vac, 50/60 Hz, 90W
Max
Export Model
208 – 240Vac, 50/60 Hz, 90W
Max
Dimensions
(HWD) 5.25” x 8.4” x 9”
(13 x 21 x 23 cm)
Weight 9.5 lbs / 4.3 Kg
Tone Controls
Bass
+8 – 12 dB @ 100 Hz
Treble +10 – 12 dB @ 10 kHz
Inputs
Balanced
female XLR, switchable phantom
power, 15 volts DC @ 6.8 k W
Mic-Level Setting Lo-Z
Line-Level Setting Bridging (10 k W)
Line Hi-Z, unbalanced, 1/4”-phone &
RCA
Outputs
Line (post fader)
Lo-Z, buffered, RCA
Speaker 8 W, unswitched, 1/4”-phone
Sensitivity For Rated Output
Line
balanced -18 dBv (125 mVrms)
Microphone balanced -56 dBv (1.5 mVrms)
Line -18 dBv (125 mVrms)
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound (Power LED Not Lit) • turn POWER switch on
• plug in power cord
• check for blown fuse
No Sound (Power LED Lights) • check for output from source
• make sure all cables are completely plugged in
• increase volume control
Distorted Sound • check input cable connection
• lower input signal level
Excessive Hum / Noise • use shielded input cable
Mic Volume Too Low • set balanced input to mic-level
Blows Fuse w/ Auxiliary Speaker • shorted speaker cable
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (Wireless Model Only)
No Sound • confirm transmitter power switch is set to on
• turn up volume control
• plug microphone into body-pack transmitter
• turn sound system on
• replace mic/transmitter battery
• make sure hands free mic cable is fully plugged into transmitter
•
Frequent Transmitter Dropouts
• replace mic/transmitter battery
• move mic/transmitter closer to AN-1000XU1+
• change transmitter to different channel