AEG DL8590-M - Manual (Page 16)

16 EN
INSTALLATION
Installation – Air outlet version
• The Hood is fi tted with a system that allows the
direction of the air outlet to be adjusted.
• On installation, the Hood is set up with the air
outlet in the Top position (fi g.1).
• To modify the position of the air outlet, remove
the Comfort Panel (see paragraph on Mainte-
nance).
• Remove the Grease Filters (see the paragraph on
Maintenance).
• Remove the profi le after unfastening the 4 screws
that fi x it to the Hood (fi g.2).
• Remove any Activated Charcoal Filters (see the
paragraph on Maintenance).
• By removing the 6 upper screws, the 6 rear
screws and the 2 screws on the inside of the
Hood, it is possible to turn the Motor Unit with
the bracket attached so that the air outlet points to
the side (fi g.3).
• To direct the air outlet to one of the various sides
(fi g.4) unfasten from the inside the screws that fi x
the upper part containing the motor to the rest of
the Hood.
• Turn the upper part as required, to the right or
left, and then refasten the screws removed as
above from the inside (fi g.5).
• Replace the profi le, using the 4 screws removed
as above.
• Replace the fi lters.
• Replace the Comfort Panel.
1
2
3
4
5