Buyers CC400 - Manual

Quality since 1946
1
2
3
4
5
6
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
CC400 4" & CC600 6" Conduit Carriers
Bill of Materials
1 3016367 1 Cap, Rear, 4"
2 3016371 2 U-Bolt 3/8-16 Thread
3 3016369 2 Saddle 4"
4 – 4 3/8 Lock Washer
5 – 5 3/8-16 Nut
6 3016383 1 Cap, Front, 4"
item part no. qty. description
3016385 Rev. A
Warranty
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repairing or
replacing any part or parts which are returned, prepaid, and are
found to be defective by Buyers Products Co. Authorization from
Buyers Products Co. must be obtained before returning any part.
No charges for transportation or labor performed on Buyers’ prod-
ucts will be allowed under this warranty.
Tools & Supplies Required
• 3/8" Drill and 3/8" Drill Bit
• Tape Measure
• Silicon Sealant
• 8 Cap Fasteners (rivets or nuts and bolts)
• Drill Bit for selected fastener
1. Assemble the front and rear covers to a length of 4" or 6"
PVC pipe. Apply a bead of silicon sealant (not supplied) to
the inside of the front and rear covers before sliding them
over the ends of the PVC pipe.
2. Secure the caps to the PVC pipe with either pop rivets
or screws (not supplied) in four places. Drill suitably sized
holes for your fastener through the cap and PVC pipe. Drill
the holes in the 2 o’clock, 4 o’clock, 8 o’clock and 10 o’clock
positions.
3. Determine the position on your truck or van ladder rack
that you would like to mount your new CC600 conduit car-
rier. Drill two 3/8" holes in each of the ladder rack cross rails
for the U-bolts and saddles. Center saddles as needed.
4. Assemble the conduit carrier assembly to the ladder rack
with the saddles, U-bolts, lock washers and nuts supplied.
Before you begin assembling the conduit carrier,
verify that you have received all the parts listed
in the bill of materials.
CC400 Conduit Kit for 4" PVC
1 3016366 1 Cap, Rear, 6"
2 3016370 2 U-Bolt 3/8-16 Thread
3 3016368 2 Saddle 6"
4 – 4 3/8 Lock Washer
5 – 5 3/8-16 Nut
6 3016382 1 Cap, Front, 6"
item part no. qty. description
CC600 Conduit Kit for 6" PVC