Buyers Cylinder Rebuild User Manual
Rebulid instructions, Cylinder rebuild instructions, Bill of materials
Quality since 1946
7700 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Rebulid Instructions
—continued on other side
Cylinder Rebuild Instructions
1
1
O-Ring, Rod Bearing
2
1
Seal, Rod Wiper
3
2
Seal, Piston
4
1
Ring, Piston Wear
5
2
O-Ring, Cylinder Cap
ITEM
QTY.
DESCRIPTION
Bill of Materials
Use these Instructions for the following replacement
parts kits:
TGC25008CKBK & TGC32508CKBK Bearing Kits
TGC25008CKRK & TGC32508CKRK Seal Kits
Rod Bearing Removal, Seal Replacement,
and Installation:
(Cylinder cap removal not required.) Leakage around the
cylinder’s rod by the brass rod bearing will normally indi-
cate that the seals and possibly the rod bearing need to
be replaced.
Rod Bearing Removal:
1. Inspect the piston rod for burrs and any foreign matter
that may prevent sliding the bearing off the rod.
2. Disconnect any attachments to the piston rod and thread.
3. Lubricate rod with a small amount of the grease supplied.
4. Unscrew the rod bearing from the cap by carefully using
a pipe wrench to grip on the outside of the bearing. (Some
cosmetic damage to bearing may occur.)