Buyers BH10 Series - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
BH10-Series Combination Hitch
—continued on other side
Hitch Capacity
4,000 lbs. Max. Vertical Load
20,000 lbs. Max. Trailer Weight
WARNING:
Maintain adequate vertical (tongue) load to properly
control the trailer (generally 10%), but do not exceed
the above rated capacities.
4. To close latch, pull plunger, rotate latch
closed and release plunger. Plunger must be fully
engaged to lock the latch. Assembly safety pin.
Operating Instructions for Ball Hitch
1. Before operating, inspect for proper opera-
tion, worn, damaged or missing parts and secure
mounting. Correct as required before use.
2. Open latch by removing safety pin, pulling
plunger and rotating latch open.
3. Replace safety pin in hole to retain latch in
open position.
4. Position ball coupler over the proper size ball
and lock into place, following the instructions of
the coupler manufacturer.
WARNING:
Other steps and inspections are also required. Consult
D.O.T. regulations and American Trucking Association for
complete coupling and uncoupling procedures.
Towing Applications
Trailers and equipment designed for over-the-road
towing within the stated capacities. For off-road
applications, reduce the capacities listed above
by 25% and use in conjunction with a swivel-type
drawbar. This pintle hook/ball hitch is well suited
for use in the utility and construction industries.
Drawbar Eye/Ball Hitch Dimensions
2-3/8" – 3" I.D. with 1-1/4" – 1-9/16" diameter section
2" or 2-5/16" SAE J 684 Ball Hitch Coupler.
Mounting
1. Use a mounting structure of sufficient strength
to support the rated capacity of the pintle hook in
accordance with SAE J849b.
2. Use the hole pattern template supplied with
the pintle hook.
3. Use four 9/16" grade 8 bolts, torque to 120 ft-lbs.
Operating Instructions for Pintle Hook
1. Before operating, inspect for proper opera-
tion, worn, damaged or missing parts and secure
mounting. Correct as required before use.
2. Open latch by removing safety pin, pulling
plunger and rotating latch open.
3. Position drawbar eye over the horn of the
pintle and lower into place.
WARNING:
Do not damage the latch. Be particularly careful with the
drawbar when coupling and uncoupling.