Buyers BDB1394 - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
BDB1394 Drawbar
— continued on back
WARNING
Maintain adequate vertical (tongue) load to prop-
erly control the trailer (generally 10%) but do not
exceed the above rated capacities.
WARNING
It is the user’s responsibility to be sure that the
pintle hook mounting surface is capable of 19,000
lbs. vertical load and 90,000 lbs. gross trailer wt.
Capacity
19,000 lbs. Maximum Vertical (tongue) Load
90,000 lbs. Maximum Gross Trailer Weight
WARNING: Maintain adequate vertical (tongue) load
to adequately control the trailer (approx. 10%
of G.T.W.) but do not exceed the above ratings.
Description
Drop forged steel drawbar with 4-bolt mounting base.
3" I.D. eye with 1-5/8" dia. section.
Towing Applications
For trailers, full trailers (including doubles) and equip-
ment designed for over-the-road towing within the
stated capacities. For off-road applications reduce the
above capacities by 25% and use in conjunction with
swivel style coupler.
Mounting
1. Use a mounting structure of sufficient strength to
support the rated capacity of the drawbar in accor-
dance with SAEJ849b.
2. Bolt pattern described on reverse.
3. Use four 7/8" grade 8 fasteners, properly tightened.
Operation & Maintenance
1. Inspect drawbar regularly for wear and damage.
If wear exceeds 1/8", replace drawbar.
2. Check the mounting fasteners for proper torque.
WARNING DURING OPERATION
1. Check to see if drawbar size is compatible with
coupling device being used on tow vehicle.
2. Do not damage the coupling components.
Take extra care during coupling and uncoupling
operations.
3. Before use inspect coupling device on the
tow vehicle.
4. Consult O.S.H.A. and D.O.T. regulations and
American Trucking Assoc. guidelines for complete
operating procedures.
General Information
1. Do NOT modify or add to this product.
2. Wear safety goggles during installation, removal and
rebuilding.
3. Never strike any part of the item with a steel
hammer.
4. Do NOT weld on this product without written per-
mission from the factory.
WARNING
This product must not be used or maintained in a
careless manner.