Buyers LT20 - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
LT20 Backpack Blower Rack
for Utility Landscape Trailers
—continued on other side
Holds most backpack blowers. Locks with a long
shackle padlock.
STIHL ® BR-340 and BR-420 owners must use rack part no. LT22.
Important!
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
CAUTION:
Always wear safety glasses when using power tools.
Utility Trailer Installation Instructions
Tools Required:
•Two 9/16" Wrenches and/or Sockets
•Electric Drill
•13/32" Drill Bit
•Carpenters Square
1. Clamp the blower rack to the trailer side rail with
the base of the upright on the trailer floor. Verify the
rack is square to the trailer deck in both directions
with a carpenter’s square.
2. After determining the position of the rack, mark
center of the two holes in the base on the trailer deck.
WARNING! Check for locations of brake lines and
electrical wiring etc., before drilling any holes.
Any damage to trailer during installation is the
installer’s sole responsibility.
3. Remove the rack from the trailer and use a 13/32"
drill bit to drill two holes in your trailer deck as marked.
4. Assemble the rack to the trailer with two 3/8-16
x 2-1/2" cap screws, four 3/8" flat washers and two
3/8-16 nylock nuts. Do not tighten screws at this time!
5. Clamp the blower rack to the rail of the trailer.
Make sure the rack is square to the rail and the deck
of the trailer with a square.
6. With the rack clamped into position drill a 13/32"
hole through the center of 1" tube and the trailer rail.
7. Fasten rack to the trailer rail with a 3/8-16 x 2" cap
screw, two 3/8" flat washers, and a 3/8-16 nylock nut.
Tighten all three screws at this time.
1 3000065 1 Weldment, Blower Rack
2 TS31 1 Strap, Rubber Tarp 31"
3 9225 2 S-Hook, 2-1/2" Zn, Tarp Strap
4 - 2 Washer, Flat 3/8 USS Zn
5 - 2 Screw, Hex Head Lag, 3/8 x 2, Zn
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials