Braun S32.533.5 Pulsonic SmartSeries - Manual (Page 15)

15
SmartGuide display unit into the fixed wall
mount.
Please note: The adhesive tape will not work on
dirt-repellent surfaces.
Cleaning recommendations
• After brushing, rinse your brush head
thoroughly under running water.
• Remove the brush head from the handle and
clean brush head and handle separately under
running water. Wipe them dry before you put
the handle back on the charging unit.
• From time to time you can also clean the
charging unit with a damp cloth. For thorough
cleaning you may remove the charger cover
(h) by pushing the release button on top of the
charging unit. The charger cover is
dishwasher-safe.
• Charging unit and SmartGuide display unit
should never be placed in water.
Synchronizing
To avoid interference of display messages
when using more than one Oral-B Pulsonic
SmartSeries toothbrushes with separate
SmartGuide display units in the same house-
hold, you need to assign the handles to their
respective SmartGuide display units.
To do so, please follow the steps below:
• Push the «h/min» button, located in the
SmartGuide battery compartment, for at least
3 seconds. The SmartGuide display unit
shows «L---», indicating the «Learn» mode for
synchronization is activated.
• Now you are requested by a flashing
on/off button in the toothbrush icon on the
SmartGuide display unit to turn the handle on.
When doing so, the automatic synchronization
process starts. It is finished when «L-1-» is
displayed.
• Then turn off the handle.
If you would like to assign a second handle to
the same SmartGuide display unit, repeat the
last two steps described above with the other
handle. You can exit the «Learn» mode by
pressing the «h/min» or «set» button. Otherwise
the «Learn» mode will automatically end after
30 seconds.
Please note:
• A maximum of 2 handles can be synchronized
with one SmartGuide display unit. After you
synchronized the second handle, «Full» will be
displayed.
• It is possible to synchronize your Oral-B
Pulsonic handle and an Oral-B Triumph handle
with your SmartGuide Display unit.
• When changing batteries of the SmartGuide
display unit, stored data will be erased.
Therefore, please repeat the synchronization
process every time you change the batteries.
set h/min
3 sec.
set h/min
3 sec.
99404877_S_32_WE 15 06.05.2010 13:24:25 Uhr