SOLO 453 Trolley-Spritze - Manual (Page 6)

- ENGLISH –
The following symbols are used in these operating
instructions and on the device itself:
Caution
Refer to the operating instructions
Wear protective clothing
Wear protective gloves
Wear face protection
A breathing mask should be worn when
using poisonous chemicals
Maintain a minimum distance of 15
metres bystanders
Safety directives and general instructions
 Compliance with this safety manual is a
prerequisite for proper operation of the sprayer.
 The pressure sprayer must be checked before
each use.
 This pressure sprayer is suitable for applying
approved liquid plant protection, insecticides,
and weed killing substances, as well as liquid
fertilizers that are available from authorized
dealers. We recommend using only plant
protection substances that are approved by the
German BBA (German Federal Biological
Institute).
 The sprayer must be cleaned when changing the
spray substance. This avoids possible chemical
reactions.
 Do not use liquids over 40°C.
 Due to bodily hazard, only the abovementioned
liquid substances may be applied with this
sprayer. Disinfectants and impregnation
substances may not be used.
 Never leave the filled and /or pressurized
pressure sprayer unattended for longer periods.
 For safety reasons, children, young people
under the age of 16, and persons that are not
familiar with these operating instructions, may
not use this pressure sprayer.
 The pressure sprayer must be kept out of the
reach of children.
 The user is responsible relative to third persons.
 The pressure sprayer must be de-pressurized
before disassembly of any component, and
before opening the pump, by pulling on the
pressure valve (Fig. 3)! Before pulling on the
pressure valve, the sprayer must always be in an
upright position. Attention: keep the sprayer
away from your face!
 Do not expose the pressure sprayer to high
temperatures.
Malfunctions of any kind, such as, for example
 leaks at the tank, spray pipe and tubing,
 signs of damage, cracks, etc.,
 other irregularities,
is the syringe immediately make pressure on the
safety valve. The sprayer must not be reused, but
must be checked by a qualified person.
The manufacturer was not aware of any harmful
effects on the product materials caused by plant
protection substances at the time the product was
manufactured.
Assembly
Firmly screw the spray tube with O-Ring (16x3
mm) onto the shut-off valve. In the process, -fasten
the threaded collar (Fig. 1, Pos.1) on straight and
firmly tighten it by hand – do not use force and do
not use any tools to firmly fasten the collar!
Fig. 2: When your work is completed, the spray
tube should be fitted into the holding clamp.
The pressure sprayer can also be carried by the
pump handle, if the pump handle is pressed down
completely, and it is turned to the right and clicked
into position.
Placing in service
The pressure sprayer must be de-pressurized
before disassembling any component, and before
opening the pump, by pulling on the pressure valve
(Fig. 3)! Before pulling on the pressure valve the
sprayer must always be in an upright position.
The pump must be removed to fill the spray liquid.
To do this, push the pump handle down and turn it
to the left (counterclockwise) until the handle clicks
into position.
Fig. 4: Unscrew pump by turning it counter
clockwise. Do not use any tools!
Fill the spray liquid to the fill mark maximum.
Model 453: 11 liters
In this regard, follow the safety directives and
insure the correct dosing according to the
instructions provided by the manufacturer of the
spray substance!
Thoroughly mix the liquid, insert pump and refasten
firmly by turning clockwise. Firmly tighten by
turning pump handle clockwise until it clicks into
position.