Billet Specialties Rail - 15.5" - Manual

2. Install Column Adapter
Align horn-post hole on adapter to horn wire connection
post on column and slide adapter on shaft with one of the
mounting holes at the 12 o’clock position. Replace steering
shaft nut and hand tighten, do not torque yet.
*Some aftermarket steering columns may not include this
piece. This can be purchased from any GM dealer, AC Delco
#26047013
3. Install Leather Ring
Lay leather ring on table with leather side down. Align holes
in steering wheel with holes in leather wrap. Holes are not
evenly spaced so the steering wheel may have to be moved
1 or 2 holes to the left until the holes line up. Start the eight
8-32 flathead screws in each hole before evenly hand
tightening them.
DO NOT OVERTIGHTEN! This will damage the half-wrap.
4. Install Steering Wheel
Position steering wheel on adapter and install nine 8-32
flathead screws, tighten down steering wheel. Check the
steering wheel to make sure it is straight. To adjust, remove
the assembly (steering wheel & adapter) and index the
adapter on the splined shaft. Once straight, torque steering
shaft nut to 20-25ft. lbs.
Non-Billet Specialties Adapter
Billet Specialties steering wheels are drilled and counter-sunk
to work with Billet Specialties adapters and use 8-32
hardware. Some aftermarket adapters are supplied with
10-32 hardware. On such applications the hardware must be
changed to 8-32.
5. Install Horn Button
Install horn wire to post on column by pushing in and twisting
to lock it in. The horn wire is not supplied with some
aftermarket columns, but is available as a replacement part
from Billet Specialties - #RP2510.
Attach black ground wire on back of the horn button to the
8-32 tapped hole in adapter using supplied 8-32 x 1/4” Phillips
screw. Insert spade connector on column horn wire to center
tab on the back of the horn button.
Important: Lube O-ring on horn button and push horn button
into bore of adapter.
6. Install Billet Profile Accent Pieces
Align and install by threading two 8-32 flat head screws
through the backside of the steering wheel spoke into the
billet accent piece.
1. Remove Original Steering Wheel
Turn wheels to a straight-ahead position. Remove original
horn button or center pad and disconnect horn wire at horn
button. Remove horn wire at column by pushing in and
turning on the wire post. Remove the steering shaft nut.
Use a steering wheel puller to remove wheel.
PROFILE STEERING WHEEL INSTALLATION INSTRUCTIONS
TECH LINE 708/588-0505 • FAX 708/588-7181
WWW.BILLETSPECIALTIES.COM
REV
. 7/07
Adapter
Top View
Steering Column
Adapter
Plastic tower goes
thru large hole in
adapter
Pigtail Wire
(Yellow)
Pigtail Wire
(Yellow)
Goes thru
large hole
in adapter
Goes thru
large hole
in adapter
Horn
Button
Adapter
(Side View)
Adapter
(Top View)
Adapter
(Top View)