Mustang Motorcycle Seats Wide Touring Two-Piece Vintage Seat - Honda VT1100 ACE No Studs, No Conchos - Manual

These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
[email protected], or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Ref part #75010, 75011, 79160, 79161
Mounting Suggestions:
Honda VT1100 ACE &
ACE Tourer 1995-01
Two-Piece Seat
Hardware:
• One Nylon Washer (Included)
• Two 1/4-20 x 3/4” Screws (Included)
Baseplate Features:
The two-piece seat is built on a marine-grade fiberglass
baseplate. Rubber bumpers are positioned to protect the
frame and fender. Solos have two powder coated
brackets that align with stock side mounts.
Stock Seat Removal Steps
1. Remove rear fender acorn nut with 10 mm wrench.
2. Remove the mounting bolt on each side of the solo
seat with a 12 mm socket.
3. Slide seat back and up.
Mounting of Mustang Seat
1. Bolt the solo and rear seat together using the supplied 1/4-20 x 3/4" screws.
2. Engage nose tab under frame below fuel tank, not under fuel tank flange.
3. Place supplied nylon washer between chrome triangle and fender
hole
.
4. Set rear fender screw loosely.
5. Install stock side bolts and tighten.
6. Tighten rear fender screw.
Enjoy the Comfort of your new Mustang Seat!