Mustang Motorcycle Seats Cyclone Frame Mounting Plate 2009-2013 Road King, FLHT, FLTR & FLHX Street Glide User Manual
Mustang Motorcycle Seats For motorcycles
Page 1 of 3
Mounting Suggestions
Harley-Davidson® FLHT, FLHX, FLTR, FLHR 2009-13
Cyclone Solo Seat and Frame Mounting Plate
Install the 2” long bolt through
the front mounting bracket
(carpet side). Place the 3/4”
long bolts with washers
through the frame mounting
plate’s center holes, hold
them in place with the rubber
washers.
Hardware Included:
(2) Chrome Washers
(1) ¾” Plastic Spacers
(2) Chrome Acorn Nuts
(1) 1/2” Plastic Spacers
(2) Black Rubber Washers
(2) Hex Bolts ¼”‐20x3/4” Long
(1) Hex Bolt ¼‐20x2” Long
(2) Flat Washer 1/4”
Flip the frame mounting plate
over, place both plastic spacers
onto the front 2” bolt. Now
thread the front bolt into the 2nd
hole in the front of the Cyclone
Solo seat, but do not tighten.
Align the two rear 3/4” bolts with
the seat’s rear threaded inserts.
Tighten all three bolts with a
7/16” wrench.
The Cyclone Solo seat can be positioned 1” further back on the frame mounting plate
by drilling the two indented marks in the frame mounting plate with a 5/16” drill.