Mustang Motorcycle Seats Studded Tank Bib - Honda VT750 Spirit User Manual
Mustang Motorcycle Seats For motorcycles
Installation Instructions for Mustang
Tank Bibs on 2001-2008 Honda
VT750 & VT750 DC Spirit
Step 1 Remove seat from motorcycle. Remove
lower tank bolt.
Step 2 Remove two screws holding dash panel to
tank.
Step 3 Lift dash panel high enough to slide tank bib
over dash panel bracket.
Step 4 Make sure that center hole in bib is centered
over the dash panel bracket.
Step 5 Lower dash panel into place on bib and
mounting bracket. When you are satisfied with the
bib’s position, install and tighten two screws to se-
cure dash panel.
Step 6 Install tank bolt through slot in bib and
tighten. Reinstall seat.
Enjoy the custom look of your new Mustang tank
bib.
These steps are guidelines to help you install your new Mustang product. If you need
further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30
Eastern or send an e-mail to
or visit our website
at
www.mustangseats.com.
For care and maintenance of our seats, please go to our website under
"Support".
Ref: part #'s 93167, 93168