Mustang Motorcycle Seats Two-Piece Vintage Seat with Driver Backrest - Harley-Davidson VRSCA & VRSCB, No Studs User Manual
Mustang Motorcycle Seats For motorcycles
Mounting Suggestions
Harley-Davidson® V-Rod: VRSCA & VRSCB 2002-2006
Two-Piece Seat
Tools Required:
• 10 mm Wrench
• 13 mm Wrench
Hardware:
• Two 6 mm x 35 mm bolts, nylon washers,
locknuts (Included)
Baseplate Features:
Both solo and rear seats are built on a black, gel coated
3/16" thick marine-grade fiberglass baseplate. Rubber
bumpers to prevent them from touching the frame or
fender.
Removal of Stock Seat
Stock Solo Seat
1. Push key in, then turn counter clockwise to release
seat lock.
2. Remove plastic hinge pin lock. Push clip off hinge
pins with a screwdriver or with your finger.
3. Remove the seat tilt limiter cable from frame. Just
push in, pull out.
4. Slide seat back to release the seat hinge pins from
frame.
Steps to remove the passenger seat continue on the next page.
Step 1
Step 2
Step 3
Step 4
page 1
Updated 10/14/10 AA