Mustang Motorcycle Seats Two-Piece Vintage Seat with Driver Backrest - Kawasaki Mean Streak & Suzuki Marauder 1600 & Boulevard M95, No Studs User Manual
Mustang Motorcycle Seats For motorcycles
These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
[email protected], or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Mounting Suggestions:
Kawasaki 1600/1500 Mean Streak,
Suzuki 1600 Marauder
& Suzuki M95 2005
Two-Piece Seat
Hardware:
• One Nylon Washer (Included)
Baseplate Features:
The two-piece, marine-grade fiberglass baseplate is a direct
replacement for the stock one-piece seat. Rubber bumpers
are strategically placed to prevent the baseplate from
touching the frame and fender.
Stock Seat Removal Steps
1. Unbolt 6 mm bolt on each side and single rear acorn
nut.
2. Slide seat back and up.
Kawasaki Mean Streak Shown
Enjoy the Comfort of your new Mustang Seat!
Kawasaki Mean Streak Shown
Mounting of Mustang Seat
1. Engage nose tab of solo.
2. Secure solo using two stock side bolts.
3. Slide bracket on front of passenger seat into receiver
on rear of solo.
4. Secure rear of passenger seat to fender with stock
acorn nut.