Mustang Motorcycle Seats Victory Cross Roads Classic, Cross Country, Hard-Ball DayTripper - Manual

Mounting Suggestions
2010 – 2013
Victory Cross Roads® & Cross Country®
One-Piece Seat
Removal of Stock Seat
1. Remove the right and left side covers exposing the seats two 8mm Allen Mounting Bolts.
2. Use a 6mm Allen Wrench and remove the seat’s two 8mm Allen bolts .
3.
Lift the nose of the seat up and then forward over the gas tank.
These steps are guidelines to help you install your new Mustang
product. If you need further assistance please call us at 800-243-1392,
Monday through Friday 9:00 - 5:30 Eastern or send an e-mail to
[email protected] or visit our website at
www.mustangseats.com .
For care and maintenance of our seats, please go to our website under
"Support".
Ref: part #s 76824, 76825, 79566, 79567
Installation of Mustang Seat
The Mustang Seat installs the same way the stock seat is installed.
1. While holding the front of the seat up over the gas tank, align the seat’s rear bracket with the hole in the
back of the frame. Be careful not to hit the tank with the front seat’s brackets.
2. Slide the seat back and down into the frame.
3. Align both sides of the seat’s U-Bracket with the seat mounting holes in the frame.
4. Install the stock seat’s two 8mm Allen Bolts and tighten with a 6mm Allen Wrench.
5. Re-install side covers.
8mm Allen Bolt on each side of the frame
Hole in
frame is
for the
seat’s
rear
bracket