Mustang Motorcycle Seats One-Piece LowDown Touring Seat Harley-Davidson Road King User Manual

Mustang Motorcycle Seats For motorcycles

Advertising
background image

Mounting Suggestions for the Harley-
Davidson® Road King, Road King Classic
1997-07, FLHRS (Custom) 2004-07, FLHT/
FLHR Screamin’ Eagle 1997-05 & FLHX
2006-07 One-Piece Seat

Tools Required:

• Phillips Screwdriver

• 5/8” Deep Socket or Open-End Wrench

• 7/16” Open-End Wrench

Hardware:

• Stock Rear Fender Screw

Baseplate Features:

One-piece touring seats are constructed on a marine-grade

fiberglass baseplate. The baseplate is slotted in the middle

to allow for the use of a Mustang or stock Harley-Davidson®

driver backrest kit.

NOTE: Seats will not work with an FLHT handrail

Stock Two-Piece Seat Removal Steps

1. Remove the rear fender screw. This screw will be used later to secure

your new Mustang One-Piece Seat.

2. Slide the passenger seat back and up.

3. Remove the solo mounting nuts (1999-07) or solo mounting bolts 5/16”x18

thread (1995-98) located at the back of the solo seat.

Stock Solo Seat Removal Steps

1. Remove the solo mounting nuts (1999-07) or solo mounting bolts 5/16”x18

thread (1995-98) located at the back of the solo seat.

2. Slide the solo back and up.

Stock One-Piece Seat Removal Steps

1. Remove the rear fender screw. This screw will be used later to secure

your new Mustang One-Piece Seat.

2. Remove hand strap that is secured to the motorcycle on each side of

the seat where the front saddle bag mount is located.

3. Slide the seat back and up.

Advertising