Mustang Motorcycle Seats Studded Pouch Tank Bib - Honda VTX 1300 Retro & C - Manual

These steps are guidelines to help you install your new Mustang product. If you need further assistance, please call us at
800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to [email protected] or visit our website
at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Ref part #93302, 93303, 93179, 93180
Mounting Suggestions:
Honda VTX 1300 C, Retro, S & T 2002-up
Tank Bib
Mounting of Mustang Tank Bib
1. Remove the gas cap and three lower dash screws with a 5
mm Allen wrench.
2. Remove seat to expose rear tank mounting bolt. Remove
the 8 mm bolt and washer.
3. Lift dash and place the tank bib around and under the three
protruding dash mounts as well as the gas cap hole.
4. Lower dash back into place then reinstall the three lower
dash screws and gas cap.
5. Install the 8 mm tank mounting bolt through the bib then
into the frame and tighten, making sure the large washer is
on top of the bib.
6. Reinstall the seat.
Step 1
Step 2
Step 3
Enjoy the custom look of your Mustang Tank Bib!
Plain Studded