Mustang Motorcycle Seats Textured Solo Seat with Driver Backrest - Harley-Davidson FLHP User Manual
Mustang Motorcycle Seats For motorcycles
Installation instructions for
Mustang Solo seat for 1983-2013
Police Air-Ride models
Stock seat removal
1. Pivot stock seat up to reveal mounting bolts.
2. Unscrew three bolts from bottom of stock seat.
These bolts will not be used with the Mustang solo
seat.
3. Remove stock seat from the pivoting bracket.
Mustang seat installation
1. Remove hex nuts from studs on bottom of Mus-
tang solo seat.
2. Position Mustang solo seat onto pivoting bracket,
aligning the three threaded studs with the holes in the
bracket.
3. Install the three supplied hex nuts and tighten.
4. Pivot seat into riding position.
Note:
Between 1983 and 2011, the stock pivoting
brackets have gone through some changes, but the
mounting hole pattern has remained constant, and
this enables the Mustang police solo to be used on
any year within this range without the need for any al-
teration or extra hardware.
These steps are guidelines to help you install your new Mustang product. If you need
further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30
Eastern or send an e-mail to
or visit our website
at
www.mustangseats.com.
For care and maintenance of our seats, please go to our website under
"Support".
Ref: part #'s 76455, 76456, 79548, 79549
Mustang Seat
#79549
shown