Mustang Motorcycle Seats Sport Touring Two-Piece Studded Seat with Driver Backrest - Honda VTX 1800C - Manual

Mounting Suggestions:
Honda VTX 1800 C 2002-08
Two-Piece Seat
Hardware:
• Stock 6 mm Acorn Nut
• One Chrome Spool Washer (Included)
• One 1”x6 mm Bolt (Included)
• Two Nylon Washers (Included)
Baseplate Features:
The two-piece, marine-grade fiberglass baseplate is a
direct replacement for the stock two-piece seat.
Rubber bumpers are positioned to protect the frame
and fender.
Stock Seat Removal Steps
1. Remove the Allen bolt on each side of solo with a 6 mm Allen wrench.
2. Remove the acorn nut at the rear of the seat with a 10 mm wrench.
3. Lift seat up and back to remove. Front and rear seat are bolted together.
Step 2 Step 1
Page 1 of 2