Mustang Motorcycle Seats Sport Touring Vintage Recessed Rear Seat - Harley-Davidson Softail Deuce, No Studs - Manual

Mounting Suggestions
Harley‐Davidson® Softail Deuce 2000‐2007
Solo and Two‐Piece Seat
Enjoy the Comfort of
your new Mustang
These steps are guidelines to help you install your new Mustang
Product. If you need further assistance, please call us at 800‐243‐1392
or 860‐582‐9633, Monday through Friday 9:00 – 5:30 Eastern or send
an e‐mail to
[email protected] or visit our website at
www.mustangseats.com .
For care and maintenance of our seats, please go to our website under
“Support” .
Refers to part numbers 79158, 79159, 79281, 75186, 75187, 75203, 75204, 75351, 75350, 79148, 79149, 79280
Baseplate Features:
All seats are built on fiberglass baseplates. The baseplates have rubber
supports at contact points. A built‐in support wing holds up the full
width of the foam.
Removal of Stock One­Piece Seat
1. Remove rear fender screw.
2. Slide seat back and up to remove.
Mounting of Mustang Seat
Solo Seat Only
1. Remove front Allen bolt used to secure fender strut.
2. Remove spacer washer between strut and frame.
3. Clip welded nose tab into the frame mount behind the fuel tank just like the
stock seat.
4. Align side brackets behind fender strut.
5. Install Allen bolts and tighten.
Passenger Seat
6. Remove stock seat bracket and install it onto the back of the Mustang passenger
seat.
7. Slide front passenger seat bracket into receiver located at back of Mustang's
solo seat as far as it can go.
8. Align rear bracket with fender nut and secure.
Steps 1 and 2
Step 6
Step 7
Hardware: Stock Rear Fender Bracket