Mustang Motorcycle Seats Studded Pouch Tank Bib - Kawasaki Vulcan 900 User Manual
Mustang Motorcycle Seats For motorcycles
These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
For care and maintenance of our seats, please go to our website
Ref part #93197, 93198, 93306, 93307
Mounting Suggestions:
Kawasaki Vulcan 900 Classic 2006-
11
& Custom 2007-
11
Tank Bib
Mounting of Mustang Tank Bib
1. Remove single dash 6 mm bolt with a 4 mm Allen wrench.
2. Lift rear of dash up about 1", then push forward off of
mounting pins.
3. Place the cutout in Tank Bib over the speedometer, then
under the front mounting pins. Pull bib back until the rear of
cutout is over the dash mounting hole. Align front of dash
with tank's mounting pins. Slide dash back until mounting
hole lines up with hole on tank, then re-install the 6 mm
Allen bolt. Tighten with a 4 mm Allen wrench.
4. Remove the two tank mounting bolts and washers with a
12 mm wrench. Re-install them through the holes in bottom
of bib. Tighten with a 12 mm wrench.
Step 1
Step 2
Step 3
Enjoy the custom look of your Mustang Tank Bib!
Step 4
Studded
Plain