Mustang Motorcycle Seats One-Piece Fastback Seat - Harley-Davidson FXR - Manual

Mounting Suggestions
Harley-Davidson® FXR 1982-94 & 1999-00
One-Piece Seat
Tools Required:
• SAE Sockets
• SAE Open-End Wrenches
• Small Screwdriver
Hardware:
• OEM Hinge & Latch System (Stock)
• Fender Bolts & Washers (Stock)
• Fender Screw (Stock)
• Mustang Nose Bracket #75080
(Optional- Sold Separately)
Baseplate Features:
Mustang one-piece FXR seats can be used on any

982-94 an
G
1999-00
models. The formed steel baseplate has a nose tab as

well as mounts
for the stock hinge and latch. Rubber bumpers

help isolate vibration and
carpet base protects the fender. If the hinge and latch are not used,
Mustang’s Nose Bracket,Part #75080, is required to engage to the nose
tab of the one-piece seat.
Stock Two-Piece Seat Removal Steps
1. Unlatch solo seat to expose the hinge.
2. Push plastic retaining clip of hinge with small screwdriver or
fingers.
3. Slide solo seat back to clear hinge and remove.
4. Unbolt the OEM hinge and latch from the bottom of the solo
seat and set aside. The OEM hinge and latch will be used on
your new Mustang One-Piece Seat.
Stock One-Piece Seat Removal Steps
1. Remove rear fender screw located at back of seat and set aside.
The rear fender screw will be used to attach the passenger seat of
your new Mustang One-Piece Seat.
2. Slide one-piece seat back and up to remove.
Stock Passenger Seat Removal Steps
1. Remove rear fender screw located at back of seat and set aside.
The rear fender screw will be used to attach your new Mustang
One-Piece Seat.
2. Loosen front mounting bolts.
3. Slide passenger seat back and up to remove.
Updated 10/14/10 AA