OSRAM DALIeco LS - Manual (Page 8)

8
DALIeco LS/PD LI, Installation + Operation
1 General information
1.1 Symbols and abbreviations used in this manual
• Bullet point, listing
1. Numbered steps in specifi ed order
 2.2 Reference to section (e.g. 2.2.) or separate manual (without number)
 13 Figure reference (e.g. to Fig. 13)
SP Abbreviation for "Short Press / Press button briefl y" (<0.5 s)
VLP "Very Long Press / Press button for very long duration" (>10 s)
1.2 Intended use
This product is specially developed and intended for use with light management systems for
lighting systems. Any other use is not in conformity with its intended use.
2 Assembly and installation
2.1 Sensor and networking  4
Names of components  3a
(1) Infrared receiver + LED display
(2) Sensor button (hidden in housing)
(3) Presence sensor
(4) 2 Shutter (set detection range/presence)
(5) Sensor housing
(6) Connection for sensor cable (4p4c)
(7) Cover
(8) Brightness sensor
(9) Retaining tangs
Connection of max. 4 sensors (3) via Y-connector (4) and sensor cable (2) at the sensor connec-
tion  5 .
2.2 Connection
Connection of the sensor cable with 2 4p4c plugs at the corresponding 4p4c sockets of the
control unit and the sensor  4 .
2.3 Assembly options for the luminaire
There are 2 different covers for this as well as the possibility of individually fi tting into the lumi-
naire housing:
• Cover (2) for installing the sensor externally through the opening (1) in the luminaire housing
 3c . The cover is placed on the sensor prior to installing the sensor and the two together
are inserted in the opening in the luminaire housing.
• Cover (2) for installing the sensor internally  3d . The cover is placed on the sensor hous-
ing. If the sensor is in the correct mounting position, the raised surface of the cover will sit
flush in the luminaire opening (1).
• Internal sensor installation without separate cover  3b .
The openings in the luminaire housing (1) must be made to accurately fit with the sensor (2).
Retaining tangs (9) on the bottom of the sensor for simple assembly on corresponding counter-
part  3a .
2.4 Assembly-location
 6