OSRAM DALI CON 1…10 LI User Manual
Page 3
Page 2/4
Operating instructions for DALI CON 1 – 10V LI
Operating instructions for DALI CON 1 – 10V LI
Page 3/4
Technical data
Designation:
Converter from DALI to 1-10V
Type:
DALI CON 1 – 10V LI
Mains voltage:
230Vac 50/60 Hz, DC not permitted
Power consumption:
approx. 1 W
Fuse protection:
External max. 10 A, (load contact is connected internally to L)
Operating temperature:
0°C to 45°C
Protection class/type of protection:
I (protective earth)/IP20
Pollution severity:
2 (dry not conductive)
Load contact L` (µ):
Relay contact internal (make contact), connected internally with L
Function switching (on/off), no reliable isolation (µ contact gap)
Load capacity L` (µ):
max. 10 A~ ohmic load
max. 5A~ ECG load
30 St.
EVG HF 1x 18W or 1x36W or
20 St.
EVG HF 2x18W or 2x36W or
15 St. QTi DIM 1x14/24 or 1x18 or 1x21/39 or 1x28/54 or 1x36 or 1x58 or
15 St. QTi DIM 3x18 or
10 St. QTi DIM 1x35/49/80 or 2x14/24 or 2x18 or 3x14/24 or 4x18 or
8 St. QTi DIM 2x21/39 or 2x28/54 or 2x35/49 or 2x36 or 2x58 or 4x14/24 or
5 St. QTi DIM 2x35/49/80
Output out:
1-10V max. -100mA DC, current sink (approx. 100 ECG or electronic
transformers– see manufacturers' data–)
Control voltage:
0-10V max. +3mA DC (power dimmers –see manufacturers' data–)
Dimming curve:
Switchable between: linear 0-10V and logarithmic 1-10V characteristic
DALI interface:
Acc. DALI standard, current input <2mA DC, interface non-polarised
Switch input (T):
Switch (make contact) for mains voltage (230Vac)
Terminals:
Plug-in terminals, single-wire: 0.3 - 1.5 mm
2
, fine-wire 0.3 – 1.0 mm
2
Mains:
L, N, PE
Terminal no.
(3, 2, 1)
Load contact:
→ L` (µ)
Terminal no.
(4) internal to L
DALI interface:
DA, DA
Terminal no.
(6, 7)
non-polarised
Switch input:
T
Terminal no.
(5)
Output out:
0-10V 1-10V DC +, -
Terminal no.
(9, 10)
polarised
Terminal 8:
NC
Terminal no. (8) must not be used.
Maximum cable lengths :
DALI wire
Î see data sheet of the corresponding controller
Push button and 0-10V/1-10V input
Î 100m
Cable routes:
The relevant wiring requirements governing cable routes, insulation,
fusing and minimum cross-sections must be observed.
Housing:
Metal casing for installation in luminaires with screw fastening,
hole spacing 180 mm
Dimensions:
WxHxD=189 x 30 x 29 mm, see dimensional drawing
Weight:
approx. 190g
Labelling:
CE
Terminal assignment: See wiring diagrams and information printed on unit