Draw-Tite 63144 BIKE CARRIER TRANSLITE - Manual

:
:
63144
4 Bike Carrier
ITEM
DESCRIPTION
ASSEMBLY INSTRUCTIONS
1. Pull bail pin from Mounting Bracket and Arm Assembly.
2. Attach Main Support tube to Mounting Bracket in orientation shown (see Diagram 1). Line up the hole near end of
main support tube with the hole in Mounting Bracket and install one (1) ½” x 3-1/4” lg. hex bolt, two (2) nylon flat
washers, and locknut as shown. Tighten locknut until it is snug. Main Support tube still must rotate following
tightening.
3. Re-install bail pin thru Mounting Bracket and Main Support tube so bike carrier is in the upright position.
4. Attach Arm Assembly to Main Support tube as shown. Line up the hole in end of support tube with hole in Arm
Assembly. Re-install bail pin thru Arm Assembly and Main Support tube.
Arm Assembly
Main Support Tube
Bail Pin
Cequent Performance Products
Plymouth, MI 48170
63144N Rev A 08-11
Printed in XXXXXX Page 1 of 9
Diagram 1
Diagram 2
Mounting Bracket
Bail Pin
Hex Bolt
Lock Nut
Nylon
Washers
Anti-
Rattle Pin
2”
Adapter
Washer
Clip
Vehicle Mounting:
1. 1-1/4” Receiver hitch use anti-rattle pin and clip as shown. Tighten with ¾”
wrench (not provided). Insert pin from drivers side only.
2. 2” Receiver hitch use 2” Adapter, anti-rattle pin and clip as shown. Tighten
with ¾” wrench or socket (not provided). Insert pin from drivers side only.