Pro Series 97192 51 Receiver - Manual

Installation Instructions Part Numbers:
51192
97192
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 13mm, 15mm, 18mm
Drill Bits: None
1. Lower exhaust by removing bolt which attaches rearmost hanger bracket to passenger’s side frame rail. Retain bolt for
reinstallation.
2. Remove existing bolts from frame rails as shown in Figure 2, (2) on driver’s side, (2) on passenger’s side and retain for hitch
installation.
3. Raise hitch into position as shown in Figure 1 and attach with existing bolts removed in step 2. Hand tighten.
4. Push hitch towards driver’s side, so that passenger’s side bracket is up against trunk pan, and tighten fasteners to
specifications below.
5. Raise exhaust back into position and reinstall bolt removed in step 1.
Note: Rotating exhaust hanger bracket before tightening will add clearance between side bracket and exhaust.
Tighten all M10 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M)
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
z 2009, 2012 Cequent Performance Products
Sheet 1 of 3 51192N 2-1-12 Rev. B
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51192F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Carrying
Ball Mount
3500 (1589 Kg.) 300 (136 Kg.)
Wiring Access Location: SUV1, SUV2
Form: F205 Rev A 5-6-05
Existing
weldnuts
Existing M10 Bolt
Existing M12 Bolt
Existing M10 Bolt
Existing M12 Bolt
Figure 1
Vehicle Forward
Driver’s Side
Frame Rail
Passenger’s
Side Frame
Rail
Remove
Bolts
Remove
Bolts
Figure 2
Note: Uses all existing
Bolts on Vehicle
Vehicle Frame
Fascia
Figure 1
Leave these bolts in
Drawbar Kit:
36061
Drawbar must be
used in the Rise
position only.
Attention:
On some vehicles
air-conditioning lines
are very close to this
attachment. Be careful
not to damage lines when
installing hitch.
Chrysler Town & Country
Dodge Grand Caravan
VW Routan