Pro Series 97171 51 Receiver User Manual

Installation instructions, Toyota corolla, Part numbers

Advertising
background image

Installation Instructions

Toyota Corolla

Part Numbers:

51171

97171

Hitch Shown In Proper Position

Wiring Access Location: PC3, 4

Equipment Required:

Wrenches: 17mm, 19mm

Existing weldnuts

2

1

If present, remove the tie down brackets from vehicle frame rail. Return bolts and tie down bracket to owner.
1.

Raise hitch into position and install fasteners as shown above.

2.

Tighten all fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)

Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)

z

2009, 2012, 2014 Cequent Performance Products

Sheet 1 of 3

51171N

1-14-14

Rev. C

1

1

1

1

Qty. (4)

Hex Bolt, M12 X 1.25 X 35 CL8.8

3

3

3

3

Qty. (4)

Flat washer ½”

2

2

2

2

Qty. (4)

Conical washer ½”

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in
the RISE position only.

Drawbar Kit:

3593

Fastener Kit: 51171F

Form F206 Rev A 5605

2000 LB (908 Kg) Max Gross Trailer Weight

200 LB (90.8 Kg) Max Tongue Weight

Frame rails

Note: Fasteners typical
both sides

2009 Fascia

2003-08 Fascia

Printed in Mexico

3

Note: 2014
Use flat washers (items 3)
as needed as spacer if
trunk reinforce interferes
with hitch installation.

For vehicles with appearance
panel:
Remove appearance panel which
covers the trunk pan.
(2)10mm
Remove the plastic rivets that
fasten the fascia tabs to the
vehicle. Note: Remove the center
of the rivet with a screwdriver.
Rivets to be reinstalled.
Return appearance panel and
fasteners to vehicle owner.

Accessory Rating

A

Advertising