Universal Audio LA-3A - Manual (Page 14)

11
Dual Unit
The LA-3A shipping carton contains all the necessary brackets and hardware required for standard 19” rack
mount. Bracket and hardware locations are shown below
Instructions
1. Set the two LA-3As next to each other as pictured. Remove the 4 screws on the top cover on
the left unit (as shown in the FRONT VIEW drawing below).
2. Remove the 4 screws on the top cover on the right unit (as shown in the FRONT VIEW drawing
below).
3. Attach one of the STRAPPING PLATES to the left unit using the 4 screws that were removed
from the top cover. DO NOT tighten the screws yet!
4. Slip the second LA-3A under the STRAPPING PLATE on the left LA-3A. Connect the two LA-3As
together by re-inserting the 4 screws that were removed from the second unit top cover.
5. Tighten up all screws while checking the alignment of the Units. DO NOT cinch too tight!
6. Carefully flip the units over on to their tops. Repeat the same process to attach the second
STRAPPING PLATE to the bottom of the LA-3As.
7. Attach both RACK EARS to the LA-3As as shown below. DO NOT tighten the screws until all
four are in place. Set the units on a flat surface and tighten all the screws while checking the
alignment of the ears.