Universal Audio 2-1176 Dual 1176LN User Manual
Page 11
Rear Panel
__________________________________________________________
- 7
-
NOTE: The 2-1176 provides two channels, each of which have identical rear panel controls.
(1) Line INPUT
-
Connect line-level input signal for each channel to these balanced XLR connectors.
Pin 2 is wired positive (hot). This signal will normally be arriving via a patchbay from a channel or bus
insert send.
(2) Line OUTPUT
-
Balanced XLR connectors carrying the line-level output signal of each 2-1176
channel. This signal will normally be routed via a patchbay to a channel or bus insert return.
(3) Input-Z switch
-
When in the up position, the input impedance for that channel will be 15K ohms,
suitable for interfacing the 2-1176 with most modern devices. When in the down position, the input
impedance for that channel will be 600 ohms, typical of older vintage gear. In some situations you may
perceive a “brighter” tone and slightly greater depth by using the 15K ohm position, even when
interconnected with vintage equipment.
(4) AC Power
Connector
-
Connect a standard, detachable IEC power cable (supplied) here.