Procom GPS-COMBI MOUNT 3.5-7.5 mm - Manual (Page 2)

SPECIFICATIONS
ELECTRICAL GENERAL SPECIFICATIONS
MODEL GPS-COMBI MOUNT 3.5-7.5 mm
ANTENNA TYPE Active patch antenna
FREQUENCY 1575 MHz
IMPEDANCE Nom. 50 Ω
POLARISATION Circular right-hand
COVERAGE Hemispherical
GAIN 28 dBic in axial direction (typ.)
CROSS-POLARISATION
ATT. > 10 dB (typ.)
SELECTIVITY > 45 dB down at ± 45 MHz
BUILT-IN AMPLIFIER
GAIN > 30 dB (typ.)
NOISE FIGURE < 1 dB (typ.)
P 1dB Approx. +7 dBm
SWR (output) <2.0
SUPPLY VOLTAGE 5 ± 0.5 VDC (3 V resp. 12 V on request
CURRENT
CONSUMPTION Approx. 25 mA
MECHANICAL (ONLY FOR THE GPS-PART)
MATERIALS Cu-nite brass
Stainless steel
Reinforced thermoplastic
ANTENNA COLOUR Black
TEMP. RANGE -35° C →+75° C
CONNECTOR FME (male for GPS) +
FME (female for mobile antenna)
RECOMMENDED
INSTALL. TORQUE 4 ± 0.5 Nm
DIMENSIONS(H x L) Approx. 30 x 89 mm
ROOF THICKNESS 3.5 - 7.5 mm
WEIGHT Approx. 114 g
MOUNTING ø19 mm dia. hole
Tools for mounting included
MOUNTING INSTRUCTIONS
Do not use sealer on rubber gasket or other places.
TYPICAL RESPONSE CURVE
GAIN AND NOISE FIGURE (dB)
GAIN AND NOISE FIGURE
AROUND GPS CENTER
FREQUENCY (dB)
VERTICAL RADIATION PATTERN