Procom MU 4-x-... User Manual

Page 2

Advertising
background image

SPECIFICATIONS

ELECTRICAL

MODEL

MU 4-X/...

ANTENNA TYPE

Collinear stainless steel mobile whip antenna

FREQUENCY

Models within 380 – 470 MHz

IMPEDANCE

Nom. 50 Ω

POLARIZATION

Vertical

GAIN

4 dB (acc. to EIA RS-329-1)

BANDWIDTH

> 15 MHz @ SWR ≤ 1.5

SWR

≤ 1.3 @ f. res.

MAX. POWER

100 W

MECHANICAL

MATERIALS

Whip:

Black-chromed stainless steel

Black-chromed brass

Mount:

Black-chromed brass

Weather- and shockproof plastics

Stainless steel

RECOMMENDED

INSTALLATION

TORQUE

4 ± 1 Nm

COLOUR

Black

HEIGHT

Approx. 59 cm (dep. on freq.)

WEIGHT

X-version: Approx. 150 g

XP4-version: Approx. 290 g

MM-version: Approx. 400 g

MOUNTING

18 mm dia. hole

INSTALLATION

The X- and CX-antenna types can be mounted anywhere on the car,

however, roof top mounting is always recommended.
The oblong X-mount can be mounted on the often very narrow strip on the

rear wing between the trunk lid and the side of the car.
Mounting can take place exclusively with access from the outside when

drilling an 18 mm dia. hole. Mounting can take place from the inside by

drilling a 14 mm dia. hole. When mounting in a 14 mm dia. hole, remove the

bottom plastic ring of the packing gasket with a sharp cutter.
When cleaning the car in car-washing machines, remove the whip using a

spanner, size 9 mm. After wash, refit the whip and tighten it lightly with the

spanner.
As the X- and CX-mounts are internally equipped with a bendable section,

the antennas can always be adjusted to an upright position independent of

the tilt angle of the installation spot.
The MiniMag (abbreviated: MM) is a small, light-weight magnetic mount with

a high attaching effect. A silicone layer applied to the contact surface

protects the car roof and ensures maximum friction.
Antennas with magnetic mount should be mounted in the middle of the

vehicle roof to ensure best omnidirectional coverage.
Within this antenna series, all whips are compatible with all mounts.
1. INSTALLATION DIMENSIONS

2. INSTALLATION STEPS

Do not use sealer on rubber gasket or other places.

Advertising