Procom PRO-phy150-5 - Manual

PRO-PHY150-5
5-Channel Hybrid Combiner for 150 MHz Transmitters
DESCRIPTION
Combining five transmitters or receivers on the same antenna.
Better utilization of good antenna position.
Five antennas on the same transmitter or receiver.
The only combining option with very small TX-TX frequency spacing.
60 W load supplied (other loads or no load as option).
ORDERING DESIGNATIONS
TYPE PRODUCT NO. FREQ. RANGE
PRO-PHY150-5-1 210001231 136 - 141 MHz
PRO-PHY150-5-2 210001232 140 - 145 MHz
PRO-PHY150-5-3 210001233 144 - 149 MHz
PRO-PHY150-5-4 210001234 148 - 153 MHz
PRO-PHY150-5-5 210001235 152 - 157 MHz
PRO-PHY150-5-6 210001236 156 - 161 MHz
PRO-PHY150-5-7 210001129 160 - 165 MHz
PRO-PHY150-5-8 210001131 164 - 169 MHz
PRO-PHY150-5-9 210001237 168 - 173 MHz
PRO-PHY150-5-10 210001238 172 - 175 MHz
SPECIFICATIONS
ELECTRICAL
MODEL PRO-PHY150-5
FILTER TYPE Hybrid Junction
FREQUENCY 136 - 175 MHz (see table)
MAX. INPUT POWER 75 W per channel
(max. 150 W with larger load)
INSERTION LOSS < 8.2 dB ± 0.5 dB @ 8 MHz BW
< 8.3 dB ± 0.5 dB @ 16 MHz BW
ISOLATION TX 1 -TX 2
(*see note)
> 32 dB @ 8 MHz BW
> 27 dB @ 16 MHz BW
IMPEDANCE Nom. 50 Ω
LOAD (**see note) 60 W load fitted (other ratings available)
SWR < 1.5 with all other ports terminated
with 50 Ω
MECHANICAL
TEMP. RANGE –30° C → +60° C
CONNECTORS N-female (other types as option)
DIMENSIONS (L x W x H) 420 x 89 (incl. conn.) x 42 mm (excl. load)
WEIGHT Approx. 1600 g (excl. load)
*The isolation between the TX ports is directly dependent on the terminating
SWR on the antenna port. With an antenna load SWR = 1.5, the isolation
between the two TX ports will be reduced to 20 dB @ 5 MHz bandwidth.
**The SWR of the load’s should be < 1.1! Each load should be able to
dissipate 4/5 of the input power.
E.g.: With 50 W input, each load should be able to dissipate 50 W x 4/5 =
40 W.
CURVES
PROCOM A/S reserve the right to amend specifications
without prior notice.
01/08/12