Procom GPS-C 2r-70-fm - Manual

GPS-C 2R/70/FM
GPS Antenna with Whip with Shock Spring for the 160
MHz, 450 MHz and FM Bands
DESCRIPTION
External antenna whip mounted on the GPS-Combi mount.
Black-chromed, conical stainless steel whip.
Sturdy, general-purpose ¼ λ antenna in professional quality.
Easily removable whip for car wash.
GPS-antenna for fixed installations.
Full hemispherical coverage.
Built-in high gain, low noise amplifier.
Right-Hand Circularly Polarized antenna (RHCP).
5 V supply voltage (3 V respectively 12 V available on request).
DC supply via RF-connector.
ORDERING DESIGNATIONS
TYPE PRODUCT NO.
GPS-C 2R/70/FM 132000061
LH 108/136-2G (optional) 200000762
DIPX 225/330-FME (optional) 200000670
SPECIFICATIONS FOR WHIP
ELECTRICAL
MODEL GPS-C 2R/70/FM
ANTENNA TYPE Mobile antenna
FREQUENCY 2 m: 145 MHz
70 cm: 435 MHz
FM band: 88-108 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Vertical
BANDWIDTH 2 m: 20 MHz
70 cm: 40 MHz @ SWR ≤ 2.0
SWR ≤ 1.3 @ f.res.
MAX. POWER 25 W
MECHANICAL
MATERIALS Whip:
Black-chromed, conical stainless steel
Black-chromed brass
Spring:
Black-chromed stainless steel
COLOUR Black
HEIGHT 492 mm
WEIGHT 50 g
MOUNTING On the GPS-Combi mount
SPECIFICATIONS FOR GPS-COMBI MOUNT
ELECTRICAL GENERAL SPECIFICATIONS
MODEL GPS-COMBI MOUNT
ANTENNA TYPE Active patch antenna
FREQUENCY 1575 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Circular right-hand
COVERAGE Hemispherical
GAIN 28 dBic in axial direction (typ.)
CROSS-
POLARIZATION ATT.
> 10 dB (typ.)
SELECTIVITY > 45 dB down @ ± 45 MHz
BUILT-IN AMPLIFIER
GAIN > 30 dB (typ.)
NOISE FIGURE < 1 dB (typ.)
P 1dB
Approx. +7 dBm
SWR (output) ≤ 2.0
SUPPLY VOLTAGE 5 ± 0.5 VDC (3 V resp. 12 V on request)
CURRENT
CONSUMPTION
Approx. 25 mA
MECHANICAL (ONLY FOR THE GPS-PART)
MATERIALS Cu-nite brass
Stainless steel
Reinforced thermoplastic
ANTENNA COLOUR Black
TEMP. RANGE -35° C →+75° C
CONNECTOR FME (male for GPS) +
FME (female for mobile antenna)
RECOMMENDED
INSTALL. TORQUE
4 ± 0.5 Nm
DIMENSIONS (H x L) Approx. 30 x 89 mm
ROOF THICKNESS Max. 2.5 mm
WEIGHT Approx. 114 g
MOUNTING ø18.0 mm dia. hole for roof thickness up to 2.0 mm
ø18.5 mm dia. hole for roof thickness 2.0 - 2.5 mm
Tools for mounting included