Procom MU 1-zg-... - Manual (Page 2)

INSTALLATION
This antenna should always be mounted on the car roof to ensure best
omnidirectional coverage. The antenna is provided with our type ZG-mount
for mounting from the outside in a 21 mm dia. hole.
The ZG-mount is provided with an M8 x 1thread mount system. This
construction meets the demand for a low-profile mobile mount with a slim
appearance and with protection against theft of the antenna whip.
When cleaning the car in car-washing machines, the whip is easily removed
using a spanner, size 12 mm. The whip is refitted again by screwing it onto
the thread stud and tightening it with the spanner.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
3. TUNING/MODEL CONVERSION
The antenna is delivered factory-tuned and requires no further tuning.
To convert an MU 1-ZG/s model into an MU 1-ZG/l model, cut off 15 mm
of the top end of the whip.
To convert an MU 1-ZG/l model into an MU 1-ZG/h model, cut off 8 mm
of the top end of the whip.
PROCOM A/S reserve the right to amend specifications
without prior notice.
02/12/11