Procom DPF 70-6... - Manual

DPF 70/6...
6-Cavity Duplexer for the 450 MHz Band
DESCRIPTION
The DPF 70/6… is a 6-cavity duplex filter for duplex radiotelephones.
The DPF 70/6… can be adjusted within the complete
406 - 470 MHz band. The duplexer can be delivered in four different
versions according to required duplex spacing.
See also “Ordering information” below.
The DPF 70/6… is primarily intended for equipment, where the TX and
RX operate on single frequencies, but it can also, however with slightly
reduced data, be used where the TX and RX operate on several
channels, i.e. within a certain port bandwidth. In the last case, factory
tuning is recommended.
The filter uses full-length ¼ cavities in a compact, extruded aluminium
housing. The chassis is made of passivated steel, and teflon insulation
has been applied in the coaxial cables and in the connectors.
The filter is black vinyl coated to prevent corrosion.
ORDERING DESIGNATION
TYPE PRODUCT NO. DUPLEX SPACING
(MHZ)
DPF 70/6 - 5/7 200000385 5 - 7
DPF 70/6 - 7/9 200000400 7 - 9
DPF 70/6 - 9/13 200000407 9 - 13
DPF 70/6 - 13/16 200000417 13 - 16
SPECIFICATIONS
ELECTRICAL
MODEL DPF 70/6...
TX/RX FREQUENCY 406 - 470 MHz
MAX. INPUT POWER 50 W
TX NOISE SUPPRESSION
ON RX-FREQUENCY
Single-channel tuned:
Multi-channel tuned, 2 MHz BW:
≥ 85 dB
≥ 65 dB
INSERTION LOSS TX-ANT AND ANT-RX
(at 10 MHz duplex spacing)
Single-channel tuned:
Multi-channel tuned, 2 MHz BW:
≤ 1.2 dB (typ. 1.0 dB)
≤ 1.2 dB (typ. 1.0 dB)
RX ISOLATION
ON TX-FREQUENCY
Single-channel tuned:
Multi-channel tuned, 2 MHz BW:
≥ 85 dB
≥ 65 dB
IMPEDANCE Nom. 50 Ω
SWR (All ports) ≤ 1.5
MECHANICAL
TEMP. RANGE –30° C → +60° C
FREQ. STABILITY Approx. 4.5 ppm/° C
CONNECTIONS BNC-female
DIMENSIONS (L x W x H) 226 x 154 x 33 mm
WEIGHT Approx. 990 g
ORDERING INFORMATION
When ordering, please use the table above to select the appropriate
ordering designation for the desired filter type. If duplex TX and RX
frequencies are stated when ordering, the duplexers are delivered factory
adjusted. If TX and RX frequencies are not stated, the filters are delivered
non-adjusted.
PLEASE NOTE
Special configurations of this filter type may be quoted on request. For
instance, the filter can be delivered with other connector types, or with
flying leads (RG 316 coaxial cable) terminated with connectors or for
soldering-connection.
TYPICAL RESPONSE CURVES @ 10 MHz SPACING
PROCOM A/S reserve the right to amend specifications
without prior notice.
18/02/13