Procom YA Mounting Bracket - Manual

YA Mounting Bracket
Stainless Steel Angle Bracket for Fixation of Antennas
DESCRIPTION
Angle bracket for fixation of antennas based on mounting on 1”
threaded water pipe.
Application 1: Fixation on vertical structures such as:
– ship’s masts, cabins and rails
– house roof ends.
(Fixation by means of screws, bolts or rivets (not supplied)).
Application 2: Fixation on vertical tubes (10 – 40 mm dia.)
(Fixation by means of steel binders (through the oblong holes)). (Not
supplied).
Application 3: Fixation on horizontal tubes (20 – 40 mm dia.)
such as:
– push and pulpit, rails and mast yards.
(Fixation by means of the supplied U-bolt fittings).
Max. antenna height: 1.25 m.
The antenna is fixed to the YA-bracket by means of the supplied
hexagon nut and serrated lock washer which is screwed onto the
antenna connector.
ORDERING DESIGNATIONS
TYPE NO. PRODUCT NO.
YA Mounting Bracket 110000032
SPECIFICATIONS
ELECTRICAL
MODEL “YA” Mounting Bracket
APPLICATION Angle bracket for antenna fixation
STAND-OFF
DISTANCE
29 mm (to antenna center line)
MAX. ANT.
HEIGHT
1.25 m
MATERIAL Acid-proof, polished stainless-steel
WEIGHT Approx. 180 g
DIMENSIONS See below
MOUNTING On vertical surfaces with rivets, bolts or screws. On
verticaltubing (10 – 40 mm dia.) with steel binders.
On horizontal tubing (20 – 40 mm dia.) with U-bolt.
DIMENSIONS
Please Note
Please note that an antenna should always be mounted as high and as
unobstructed as possible. Objects in the vicinity of the antenna, especially
parallel metallic parts (other antennas, wires etc.) may have considerable
degrading influence on the SWR and the radiation pattern of the antenna.
Inside the marine sector the 1” water pipe mounting system for antennas
has gained worldwide acceptance. The antennas are equipped with a
revolving nut, which fits 1” threaded water pipe. From the Procom line of
marine antennas the following models, which are designed for this type of
fixation, can be mentioned: CXL 3-1, CXL 2-1/..., MA 2-1SC, CXL-VHF/GSM,
MARCELL, MARCELL 3+, CXL 70-1/…, CXL 70-3/..., CXL 900-1/…, CXL 900-
3/…, CXL 1800-1/…, CXL 1800-3/..., CXL 1800-6/..., CXL 2400-1/..., CXL
2400-3/..., CXL 2400-6/...,CXL 900/1800, CXL 900/1800/1900 and GPS 4/…
Using the YA-Bracket to mount these antennas, the revolving nut is not
applied. Instead, the antenna connector is used for fixation. The YA-Bracket
is a member of a complete family of different mounting clamps for 1”-pipe
mount antennas. Below the complete programme is shown. By means of
one of these accessory items, a vast majority of all installations can be
undertaken.
OTHER ACCESSORIES
PROCOM A/S reserve the right to amend specifications
without prior notice.
11/11/11