SCANTECH ID (Champtek company) SG300RFM - Manual (Page 41)

37
4.14 Code 2 of 6
> Check Digit Transmission
Do not Calculate Check
Digit
<Calculate Check Digit and
Transmit>
Calculate Check Digit and
Not Transmit
>
Setup Code Length
1. Scan the “Set Begin” Bar Code (2 Sets
Available)
2. Go to Decimal Value Table in Appendix A, scan
Bar Code(s) that represents the code length
3. Scan the “Complete” Bar Code
Repeat Steps 1-3 to set additional lengths
< Variable>
The output would be the
same as the barcode’s length.
There is no limit in length for
the reading output.
Fix Length (2 Sets Available)
1
1st Set Begin
2
Decimal Value Appendix A
3
1
st
Set Complete
1
2
nd
Set Begin
2
Decimal Value Appendix A